#6227
fdoyal51 wrote:
Sun Jan 07, 2018 12:03 pm
I don't mind sheet mod if I could get it but with the UFO base not sure it could be done. For sheet mode I assume the PE sensor would have to be reinstalled in the printer or start with a whole new setup ..
If the UFO electronics are setup for sheet mode there isn't anything you can do. It would be code changes.

You could try plugging in the original PE sensor and holding it triggered when you boot up the printer. That might put it into sheet mode. Worth a try, but I assume UFO would've suggested that if it works easily.
#6349
]Good news,, Got my diy dtg Epson r3000 printer back into roll mode after constant Paper Jammed messages.. I bought another R3000 used on Ebay. I had to set it up roll mode, which was a peace of cake.. Once that was done I remove it's main board and swapped it out with the troublesome r3000 main board, that solved the problem and now both printers functioning fine. Nice thing is the printer I bought on Ebay can still put into roll mod, or used sheet mode.. I need to thank Dave at UFO printer,, he gave me the idea how to go about it...
Andy liked this