Chevelle

Thank you has worked for two prints now. such a simple solution, hopefully it continues. Thank you so much

Hello Everyone My epson 15000 has decided it only wants to print half the page down either side or a strip down the middle and this could be either side, its a bit all over the shop. Any suggestions?

Mine did the same thing when i bought it, I just use a piece of cardboard on top of output try level where the sides of the output tray go up.

Hi thank you Im having the issue once again but it is starting to print the design where it wants too as in, sometimes its missing the beginning of the design and starting two cms into the design so cutting it off and im not sure where to find the paper width on/off in acro, there is only check paper, which is off

Hello everyone Got my printer to print now and another issue has arisen. Its only printing half the design down the side of the page. Ive seen this happen with the length of the page but never the side. Does anyone have any ideas what this could be. thank you for your help

Thank for that info. Ive just spent the money buying Acrorip to the tune of $650 as that is what was recommended by the company. So i would really like to try and sort the issue out first.

Hello Im new to DTF, have done dtg before so familiar with Acrorip. When i go to print an error comes up in Acrorip with Print Error: WHITE (EMPTY). New chip-less cartridges. It is also smudging the the ink at the end of the print, do you think that is because the front assembly was taken out with the rollers and its now un-level and flicking the last bit of the page up to hit against the cartridge carriage. Any ideas and suggestions would be so greatly appreciated. Chevelle xx

Hello When i go to print an error comes up in Acrorip with Print Error: WHITE (EMPTY). New chipless cartridges. It is also smudging the the ink at the end of the print. Any ideas and suggestions would be so greatly appreciated. xx