mwfigueroa

Soon I will try the following water-cooled configuration, for hard work without stopping

I add the STL part V-Slot 20x40x60 Fan Adapter2.STL

Because I using a RAMPS 1.4 for all project

Dear Reptilesink I use a MFR1100 for current, 11A PTC Replacement fuse for RAMPS which protects the heated bed output against over-current.

There are two nuts un first Photo you can see, It is true what reptilesink says, this is not recommended for hard work, I test it for common uv print and it works well by adjusting the PWM to 75%.

Dear I use PWM for control

Hi, This is some pictures of my lamp Im build with a mosfet for switching, the configuration is simple, 10k to the gate and 100k to the source in the drain there are +VCC 12V 3A for 4 units UV LED of 10W connecting in parallel and the fan getting the air from down to up of the sink.