Jump to content

Sundripped

Members
  • Posts

    1
  • Joined

  • Last visited

Sundripped's Achievements

0

Reputation

  1. Hello all, New to DTF transfers and have been having a problem with graphics not appearing to have a solid finish, which especially shows up on black. I am using an Epson SureColor F2100, Ecofreen d-film-efn-sq-1416 transfer film and ecofreen powder. All material is pressed at 300 degrees for 10 seconds to straighten it out, transfers are then warmed for 1-2 minutes under the press, then applied at 300 degrees for 20 seconds, peeled cold and finally pressed another 10 seconds at 300 degrees. Attempting to change time, pressure and temp hasn’t resulted in any change. I’ve attached a photo, has anyone encountered anything similar to this and has any suggestions?
×
×
  • Create New...