By Andy - AdminThis is a light / core version of our full OpenDTG code that is available to paid members.
Fully functional but does not have the following features of the paid version:
Support for physical buttons, it uses the desktop app only No automatic 2 pass No code to allow full removal of the ASF assembly Requirements:
OpenDTG Desktop App needed to control platen Encoder and bounce2 libraries installed in Arduino IDE 5v to 3v step down of PE signal to protect the Epson mainboard. ASF assembly must be left intact. 30 Tooth Pulley for the belt drive
By Andy - AdminArduino IDE for uploading / editing OpenDTG code. Also, installs drivers so you can use the OpenDTG desktop app.
After installation you need to add libraries if you plan on uploading the OpenDTG code to an Arduino or AIO conroller:
By Andy - AdminThis free program allows you to see error codes, do ink charges, head cleans and reset waste counters.
The only thing they charge for is the waste counter resets.
This tool is a must have for running a DIY DTG printer.
By Andy - AdminCompatible with all versions of our DTG code. Allows you to control the platen on your computer instead of using physical buttons.
Requires USB cable to be plugged into your Arduino or OpenDTG controller board.